How to extend atwood levelegs?
Press the ON button. For each jack, hold down the EXT button and press the two buttons adjacent to a corner for ten seconds to extend each jack slightly. Have someone watch the jacks and make sure they all move. Press and release the RET and ALL buttons together to bring the jacks back up.
What to do if your Atwood levelegs won’t move?
If your Atwood Levelegs electric jacks quietly refuse to move, make sure that the engine is running, the rig is in park, and you have the parking/emergency brake set.
Why are the leveling jacks on my RV not working?
We’ve had a handful of members write in wondering what to do when the leveling jacks on their RV’s slide room, fifth wheel or tow trailer aren’t working properly. For most of these cases, their hydraulic system has either taken on a disturbing growling noise upon descension of the leveling jacks or they simply won’t retract back into the rig.
Which is the correct way to level an RV?
Here are some of the replies: Rick says “Depends on the manufacturer. Newmar says slides out, then level”
What should I do if my levelegs motor is not working?
If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning. They come off fairly easily when fully retracted. Obviously, you don’t want to be removing or even loosening them when they are extended and holding up the rig.
We’ve had a handful of members write in wondering what to do when the leveling jacks on their RV’s slide room, fifth wheel or tow trailer aren’t working properly. For most of these cases, their hydraulic system has either taken on a disturbing growling noise upon descension of the leveling jacks or they simply won’t retract back into the rig.
If your Atwood Levelegs electric jacks quietly refuse to move, make sure that the engine is running, the rig is in park, and you have the parking/emergency brake set.
What to do when your levelegs system goes into error mode?
Solution: Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated.
If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning. They come off fairly easily when fully retracted. Obviously, you don’t want to be removing or even loosening them when they are extended and holding up the rig.
